Table of Contents
Advertisement
Installing HP-UX and Other Application Software
To install or update HP-UX, refer to the
To con gure your HP-UX system into a diskless cluster environment and to add a diskless
cluster node, use the SAM(1M) command. Note that you must go into single user mode of
your HP-UX system to change your kernel to the diskless cluster environment. For details, see
Managing Clusters of HP 9000 Computers
If the swap space size is not large enough for the recommended environment
Note
(see Table 5-1 or Table 5-2), modify the kernel con guration of the HP-UX
system as described in \Recon guring the HP-UX Kernel" of the
System Administration Tasks
Required Swap Size and Memory for Series 300 Computers (Runtime
Recommended Environment Minimum
Standalone Environment
Diskless Cnode Environment
Hewlett-Packard recommends to keep more than 30 MB (61440 blocks) of swap space for X11
1
Windows or HP Visual User Environment (VUE).
Hewlett-Packard recommends to install at least 16 megabytes of memory for the X11 Windows
2
environment.
Required Swap Size and Memory for Series 700 Computers (Runtime
Recommended Environment Minimum
Standalone Environment
Diskless Cnode Environment
After loading the HP-UX lesets from the master tape, Hewlett-Packard recommends to
customize
/.profile
le
/.profile
To suppress the display type query when you log in as a root user, modify the /.pro le le
as follows:
5-4 Software Installation
Installing and Updating HP-UX
Environment)
Disk Size
200 MB
|
Environment)
Disk Size
400 MB
|
and
properly for your console:
/etc/ttytype
manual.
manual.
Table 5-1.
Swap Size
(1 block = 512 bytes)
20 MB (40960 Blocks)
20 MB (40960 Blocks)/cnode 8 megabytes
Table 5-2.
Swap Size
(1 block = 512 bytes)
60 MB (122880 Blocks)
60 MB (122880 Blocks)/cnode 32 megabytes
.
HP-UX
1
2
Memory
8 megabytes
Memory
32 megabytes
Advertisement
Table of Contents
