Table of Contents
Advertisement
Mass Storage Unit
Table 2-5 lists option 720, and 740 rack mount kit contents for rack mounting the hard disk or
cartridge tape drive. Check the contents of the kit against Table 2-5 before proceeding.
Table 2-5. Options 720, and 740 Rack Mount Kit Contents
Item
(1) Support Shelf
(2) Strap
(3) Front Panel for 9133H, 7957A/B, 7958A/B/S,
7959A/B/S, 7962B, 7963B, C2212A, and C2213A
(4) Cup Washer
(5) Insert Washer
(6) Screw
Option 720 part number.
1
Assemble the rack mount kit and install the hard disk or cartridge tape drive into the top
blank space of the system cabinet as described in the following procedure. Refer to Figure 2-7.
Note that the parenthetical numbers in the following procedure are keyed to the Item column
in Table 2-5 and to the parenthetical numbers in Figure 2-7.
Mass Storage Installation Procedure:
1. Lay the support shelf (1) on a
at surface.
2. Thread the strap (2) as follows:
a. Position the buckle, with the protective pad facing down and the free end of the strap to
the right, near the left-hand strap hole on the support shelf. Make sure the strap is not
twisted.
b. Feed the free end of the strap into the right-hand strap hole of the support shelf, then
out the left-hand strap hole.
c. Lay each end of the strap over the sides of the support shelf.
3. Place the mass storage unit on the support shelf, making sure the four feet of the unit t
into their holes on the shelf.
4. Fasten the strap as follows:
a. Thread the free end of the strap through the strap buckle.
b. Position the strap buckle on one side of the hard disk or cartridge tape drive.
c. Tighten the strap around the mass storage unit, but not too tightly. There should be
enough slack to lift the buckle approximately 12.7 mm (0.5 in) away from the mass
storage unit.
d. Close the buckle, securing the strap.
5. Place the mass storage unit and support shelf assembly on the side rails of the cabinet and
push the assembly into the cabinet.
6. Place a cup washer (4), then an insert washer (5) on each
at-head screw (6).
2-14 System Controller Installation
Description
HP Part Number Quantity
04062-00198
1
9223-0678
04062-00252
1
3050-0007
3050-0248
2680-0119
1
1
1
4
4
4
Advertisement
Table of Contents
