Toshiba GR-200 Series Instruction Manual page 944

Motor test (Mot-Test)
(vii)
Settings [Mot-THM-Test], [Mot-STPH-Reset], [Mot-THM-Ip]=On allows for the user to have
motor tests. See Chapter
Test for BI and BO circuits
14.4.3
Binary input circuit test (SLOT*BIxx-SET)
(i)
Setting [SLOT*-BIxx-SET] allows to have a virtual input at a binary input circuit.
Binary output circuit test (SLOT*BOxx-SET)
(ii)
Setting [SLOT*-BIxx-SET] allows to have a virtual output at a binary input circuit.
Note: For the BI and BO test operation, see Chapter
separately (→p. 900).
Test for mode change (MDCTRL)
14.4.4
The function is provided to detect a test mode. For more information, see Chapter
control function: Mode control function
LED light test
14.4.5
The user can perform LED lighting test by pressing the keys ◄ and ►. Press the both keys on
the front panel for a few seconds. If there is no problem, all LEDs will be lit.
Test for control application
14.4.6
Transmission signal for point-to-point test with forcibly signal control
(i)
(FSCxx-SET)
Settings [FSC01-SET] to [FSC32-SET]=On allows for the user to have point-to-point
transmission signal test using hypothetical signals. See Chapter
Miscellaneous
(→p. 850).
Relay application: Motor protection
, separately (→p. 400).
- 925 -
6F2T0200 (0.15)
.
(→p. 318)
User interface: Test sub-menu
Communication protocol:
GRE200 (1,2)
,
General