Toshiba GR-200 Series Instruction Manual page 838

Multi functional protection ied

Hide thumbs Also See for GR-200 Series:

IEC 60870-5-103 communication

The IEC 60870-5-103 standard is one of the communication protocols when measuring data is

required to communicate between the control system and an IED. The communication is

carried out with RS485 or Fiber optic interface†. The data, measured and status, is transferred

over the IEC 60870-5-103 communication. The user has to make the configuration of the IEC

60870-5-103 with GR-TIEMS engineering. See

Measured data: current, voltage, active power, reactive power, frequency

Status data:

†Note: Selecting a communication module (interface) is dependent on the ordering about

the hardware selection. With regard to the communication specification, see

(→page 528).

Selection of IEC60870-5-103 protocol

Figure 11.5-1 shows the selection menu of a slave protocol. The user should set IEC103 for the

[Slave Protocol] if the IED has to communicate in the IEC60870-5-103. Note that the user has

to restart the IED (i.e., the user has to turns it off, and on) after switching a protocol from the

Communication

SLAVE PROTOCOL

Figure 11.5-1 Selection of IEC103 on commination setting menu

Note: This sample menu illustrates how to select the IEC103, so that we discuss neither

the inclusion of IEC61850, DNP3.0, and Modbus nor the selection of those

protocols here. See Figure 11.1-1 to check the inclusion of the protocols in the IED.

The slave operation can be switched off briefly if the setting [103BLK] = On.

Communication

SLAVE PROTOCOL

Figure 11.5-2 Canceling the IEC103 operation (LCD setting menu)

events, fault indications, etc.

Technical description: Signal processing and communication module

SLAVE PROTOCOL

Slave Protocol

Chapter Engineering tool

SLAVE PROTOCOL

set [103BLK]=On

6F2T0200 (0.15)

, , ,  to

GRE200 (1,2)

Chapters

Gre200-1 Gre200-2