NEC UNIVERGE SV8300 Command Manual page 110

COMMAND CODE TITLE:
08
585 Whether the service which is set to a group member station is
effective when the group members are called by Group Feature
Key
NOTE:
When the second data of CM08>585 is set to 0, the following services are effective.
Call Forwarding-All Calls/Split Call Forwarding-All Calls/Call Forwarding-All Calls of Mobility
Access/Do Not Disturb/Transfer the call to station set Do Not Disturb (CM51 Y=10)/Call Forwarding-
Logout
588 CID Call Back when an incoming call is forwarded, when a
station to which a call terminated is busy, or when a station to
which a call terminated is set Do Not Disturb
NOTE: CID Call back by this command is available under the following conditions.
• The Multiline Terminal station line is set to Call Forwarding-All Calls/Call Forwarding-Busy Line/
Call Forwarding-No answer/Call Forwarding-IP Station logout when a trunk call is terminated.
• The Multiline Terminal station line is set to Do Not Disturb when a trunk call is terminated.
• The Multiline Terminal station line received the incoming call is busy when a trunk call is termi-
nated.
592 Setting of the Caller ID information sending format
NOTE: A system reset is required after setting this command.
593 Call termination to My Line while the station user makes a call
with a Sub line or a trunk line on a Multiline Terminal
BASIC SERVICES
BASIC SERVICE
0 Effective
1 Ineffective
0 To provide
1 Not provided
0 CCITT V.23 modem (Data Format:
ETSI)
RESET
1 Bell 202 modem
0 To activate the service (Call Forward-
ing/Station Hunting) that set an
incoming call
1 As per CM08>268 (the calling station
hears RBT, or performs a Voice Call)
3-61
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08