NEC UNIVERGE SV8300 Command Manual page 580

COMMAND CODE TITLE:
E8
DATA TABLE
Y
No. MEANING
0 Firmware
download
2 Read the status of
firmware download
UPDATING OF ACCESS BLADE FIRMWARE
1ST DATA
DATA MEANING
XX ZZ XX: Unit number
(01-50)
ZZ : Slot number
(01-18)
NOTE 1: The appropriate access blade is reset when executing download, then
the firmware update starts. The cycle of the Live LED becomes special
cycle during updating.
NOTE 2: After the firmware update is completed, the access blade is reset auto-
matically and activated.
NOTE 3: Refer to the "PC Programming Manual" for the operating procedure
to update the blade firmware program.
XX ZZ XX: Unit number
(01-50)
ZZ : Slot number
(01-18)
2ND DATA
DATA
XX YY ZZ Readout data of firmware
when operating
XX: Firmware type (Same as
second data of CM05
Y=0)
YY: Firmware version on the
blade
ZZ : Firmware version of the
blade supplied with the
basic software
XX Input data when executing
download
XX: Firmware type to down-
load (same for the sec-
ond data of CM05 Y=0)
FFFF
Download is completed
(normal end)
FFXX
Download is completed
(system data except CM05
Y=0 is not set)
XX0F
Under downloading
F00F
Abnormal end under down-
loading
Under normal operation after
00FF
download (after reset)
Blade is unmounted/system
0000
data is not set
XX: 01-0E
3-531
RELATED
COMMAND
MEANING
CM05 Y=0
CM05 Y=0
NWA-033623-001 Rev.3.0
CME8
91ch3008.fm
JULY/18/2008