NEC UNIVERGE SV8300 Command Manual page 111

COMMAND CODE TITLE:
08
BASIC SERVICE: 600-699
600 Selection of trunk route seized for Call Forwarding-All Calls/
Busy Line/No Answer-Outside, Split Call Forwarding-All
Calls/Busy Line/No Answer-Outside
602 Reset of Queue Limit counter for TAS per tenant
603 Caller ID/CPN/ANI to Single Line Telephone from CCIS
606 Link Reconnect-CCIS
607 Reconnect the CCIS link when a call is connected to UCD
Delay Announcement via CCIS
608 Call Forwarding type when an incoming call terminates via
CCIS
624 Alternative Routing when the LAN cable of VoIPDB is pulled
out in tandem office or when all outgoing trunks of tandem
office are make busy condition
626 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the system does not receive the fol-
lowing DID number within the time set by CM41 Y=0>109,
after the first DID number of the calling party is received
[For EU]
627 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the DID number of digits received
from ISDN is more than the maximum number of digits
assigned by CM85 Y=0-7
[For EU]
628 Link Reconnect-Peer-to-peer CCIS
NOTE:
This command is effective when CM08>606 is set to 1.
BASIC SERVICES
BASIC SERVICE
0 By calling party's tenant/terminating
trunk's tenant
1 By Call Forwarding setting station's
tenant
0 Not provided
1 To provide
0 To provide
1 Not provided
0 Not provided
1 To provide
0 To provide
1 Not provided
0 As per CM65 Y=37/38/39
1 As per CM65 Y=23/24/25
0 To provide (CGC sending)
1 Not provided (CFL sending)
0 Not connected
1 To connect
0 Not connected
1 To connect
0 To provide
1 Not provided
3-62
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
CM08