NEC UNIVERGE SV8300 Command Manual page 36

ERROR MESSAGE
SD CODE NOT
ALLOWED/CODE
NOT ALLOWED
NOTE
CM CODE NOT USED/
CODE NOT USED
NOTE
FD CODE NOT USED/
CODE NOT USED
NOTE
SD CODE NOT USED/
CODE NOT USED
NOTE
DATA NOT FOUND
WAIT, BUSY NOW
ASSIGNED ALREADY This error message is displayed when
HARDWARE ERROR
Error Messages
MEANING OF MESSAGE
Second data which is not allowed in
the current status.
The command code entered is not in
use, or password is needed.
The first data entered is not in use, or
password is needed.
The second data entered is not in use,
or password is needed.
A station number not assigned has
been entered.
The station or trunk, for which data
is to be changed, is busy.
not enough digits are entered. For
example, when assigning "12" for a
service access code, even if "123"
has been already used for another
service access code.
Memory read/write disabled.
Check whether the second data is
available or not.
Depress "ST" or "CE" and enter the
correct data.
Depress "ST" or "CE" and enter the
correct data.
Wait until it becomes idle.
Depress "ST" or "CE" and enter the
correct data.
Check the switch setting of CPU
blade or replace the CPU blade with
spare.
1-21
Chapter 1 HOW TO USE CAT
ERROR MESSAGES
ACTION
Continued on next page
NWA-033623-001 Rev.3.0
91ch1001.fm