NEC UNIVERGE SV8300 Command Manual page 113

COMMAND CODE TITLE:
08
677 Output message which is sent from PBX to ISDN network
when the 2nd line is released by Mobility Access hooking
NOTE: This data is effective only when the 2nd data of
CM08>676 is set to 0.
679 Registering fault information (fault kind 043) by RTP monitor-
ing via SIP trunk
NOTE 1:
This command is effective when the fault information (fault kind 043) is assigned by CMEA Y=2.
NOTE 2: When the second data of CM08>679 is set to 1, the registering fault information (fault kind 043) by
RTP monitoring via SIP trunk is performed as follows.
• When releasing the path by RTP monitoring via SIP trunk is provided (CM08>672: 0), the fault
information (fault kind 043) is registered whenever the path is released by RTP monitoring.
• When releasing the path by RTP monitoring via SIP trunk is not provided (CM08>672: 1), the
fault information (fault kind 043) is registered only one time.
685 Send DTMF signals to the other office station/trunk when the
connection between DT700 Series via IPT (P2P CCIS) and
other office station/trunk is established.
699 "DND" display on Multiline Terminal/DESKCON when the
Multiline Terminal/DESKCON calls a station set the DND over
CCIS
BASIC SERVICES
BASIC SERVICE
0 CALL PROC + ALERT + DISC
1 CALL PROC + ALERT +
CONNECT + DISC
0 Not provided
1 To provide
0 To send
1 Not sent
0 To provide
1 Not provided
3-64
: Default
SETTING DATA
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08