Notice On Cat Mode; Command List Set By Standard System Data Assignment - NEC UNIVERGE SV8300 Command Manual

NOTICE ON CAT MODE

(1) The CAT is used in on-line. Therefore, system data clear commands (CM00, CM01) cannot be
accessed from the CAT.
(2) To use the CAT after clearing all system data, perform the following operations on the system.
1. Plug a DLC blade into Slot01 accommodated in Unit01 (for Multiline Terminal).
2. Connect the CAT (Multiline Terminal) to Physical Port No. 010101 at the MDF or Virtual Port
No. 0000.
3. Set SENSE switch on the CPU blade accommodated in Unit01 to "A".
4. Press RESET switch on the CPU blade accommodated in Unit01.
5. Check the LED status.
• RUN LED lights and SYSD LED flashes while loading the standard system data.
• RUN LED and SYSD LED go off and S2 LED lights when the standard system data is loaded
normally.
• RUN LED and SYSD LED go off and ALM LED lights if the loading of the standard system
data fails.
6. Set SENSE switch on the CPU blade accommodated in Unit01 to "1".
7. Press RESET switch on the CPU blade accommodated in Unit01.
CPU will reset automatically after SENSE switch is set to "1".
NOTE 1:
All pre-set data is deleted when loading the standard system data.
NOTE 2:
When a call is connected to a line at loading the standard system data, the call is disconnected
at the point of pressing the RESET switch.
NOTE 3:
Pre-registered license data is maintained even if the standard system data is loaded.
NOTE 4:
The station call is not available by just loading the standard system data. Besides, the system
data setting for stations is required.
NOTE 5:
The following data is automatically set when loading the standard system data.

Command List Set by Standard System Data Assignment

COMMAND
Y NUMBER
CODE
00
05
1ST DATA
1
0 0101
2ND DATA
CCC System Data All Clear
10 DLC blade registration of Slot No.
01 of Unit No. 01
1-10
Chapter 1 HOW TO USE CAT
NOTICE ON CAT MODE
REMARKS
Continued on next page
NWA-033623-001 Rev.3.0
91ch1001.fm