[Cm00] System Data Memory All Clear/Billing Memory Clear - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
00
FUNCTION:
This command is used to confirm that system data memory (RAM) area can be written-in/read-out, and
to assign the default to the RAM area.
PRECAUTION:
(1) This command can only be used in off-line mode.
(2) When this command is executed, "OK" is displayed with memory clear completed (about 10
seconds later).
(3) If an error exists in memory, "WD ERROR" is displayed.
(4) This command is not available with a CAT.
To clear all system data, set SENSE switch on the CPU blade accommodated in Unit01 to "A", and
depress RESET switch on the CPU blade accommodate in Unit01. In this case, the only functional
port is Physical Port No. 010101 or Virtual Port No. 0000, which is assigned as a CAT.
ASSIGNMENT PROCEDURE:
+ 00 + +
ST DE
SYSTEM DATA MEMORY ALL CLEAR/BILLING
MEMORY CLEAR
MEMORY AREA
+
DESIGNATION DE
(1/2digit)
+ CCC +
EXE
3-3
CM00
OFF LINE
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008