[Cm12] Station Class-1 - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
12
FUNCTION:
The features for each station are determined by assigning Station Class-1 to each station number.
PRECAUTION:
(1) When assigning Station Class-1 to Multiline Terminal by this command, enter
"X-XXXXXXXX (My Line number)" of FX-FXXXXXXXX, which is assigned by CM10 Y=00,
as the first data.
Also when assigning to IP Station, enter "X-XXXXXXXX (IP station number)" of
FX-FXXXXXXXX, which is assigned by CM10 Y=01, as the first data.
(2) The data for Single Line station number, My Line number of Multiline Terminal, Virtual Line
station number, Automatic/Manual/Dial Intercom number, Loop Line number and ICI/OPR Line
number, IP station number are shown in the table on next page.
(3) The table below shows the key layout for Line/Trunk/Feature Keys and One Touch Keys of the
Multiline Terminals.
CM12 Y=24: 7 (A mode)
DT330/
LINE01 LINE02 LINE03 LINE04 LINE05 LINE06
DT730
LINE07 LINE08 LINE09 LINE10 LINE11 LINE12
(12D)
DT330/
LINE01 LINE02 LINE03 LINE04 LINE05 LINE06
DT730
LINE07 LINE08 LINE09 LINE10 LINE11 LINE12
(24D)
LINE13 LINE14 LINE15 LINE16
DSS01 DSS02 DSS03 DSS04 DSS05 DSS06
LINEXX: Line/Trunk/Feature Key
DSSXX : One Touch Key
STATION CLASS-1
LINE17 LINE18
CM12 Y=24: 0 (B mode)
Same as CM12 Y=24: 7 (A mode)
LINE01 LINE02 LINE03 LINE04 LINE05 LINE06
LINE07 LINE08 LINE09 LINE10 LINE11 LINE12
LINE13 LINE14 LINE15 LINE16 LINE17 LINE18
LINE19 LINE20 LINE21 LINE22 LINE23 LINE24
3-117
CM12
Continued on next page
NWA-033623-001 Rev.3.0
91ch3002.fm