NEC UNIVERGE SV8300 Command Manual page 579

COMMAND CODE TITLE:
E8
(5) The download status of the firmware can be confirmed by the following methods.
DOWNLOAD STATUS
Download is completed
(normal end)
Download is completed
(system data except CM05 Y=0 is
not set)
Under downloading
Abnormal end under downloading RUN LED is undefined
Under normal operation after
download (after reset)
Blade is unmounted/system data is
not set
(6) The firmware can be also updated to the older version than the current firmware version of the
blade.
(7) To pull out a blade under downloading causes abnormal end. The download becomes available
again after time-out period is elapsed (approximately 3 minutes [depends on the file size] later after
the download start) when the download is ended abnormally.
ASSIGNMENT PROCEDURE:
ST + E8Y + DE
UPDATING OF ACCESS BLADE FIRMWARE
BLADE LED
INDICATION
RUN LED
(flash)
RUN LED is undefined
(such as OFF, ON)
Live LED
(flash with special cycle)
(such as OFF, ON)
RUN LED
(flash)
1ST DATA
+ + DE +
(4 digits)
CONFIRMATION METHOD
CME8 Y=2
FFFF
FFXX
(XX: 01-0E)
XX0F
(XX: 01-0E)
F00F
00FF
– 0000
2ND DATA
+ EXE
(1-6 digits)
3-530
CME8
CME8 Y=0
Firmware version is
changed
Firmware version is
changed
Firmware version is not
changed
Firmware version is not
changed
Firmware version is
changed
–
NWA-033623-001 Rev.3.0
91ch3008.fm
JULY/18/2008