NEC UNIVERGE SV8300 Command Manual page 308

COMMAND CODE TITLE:
40
Y
No. MEANING
06 RTS signal sent to
terminal
07 CS control
08 Data speed
13 DRS signal sent
to terminal
NOTE 8
NOTE 1:
This data setting of Port Location Number 4-7 is available when resetting the system or wait-
ing for 10 minutes after this data setting.
NOTE 2:
CM40 Y=00>14 should not be assigned when using Built-in SMDR in Local Office of Cen-
tralized Billing-CCIS.
NOTE 3:
When using CPU RS-232C port for PCPro, set the default to CM40 Y=01-06.
NOTE 4:
The second data of CM40 Y=01-07 must be set to default and the second data of CM40 Y=08
must be set to 1 (1200 bps) when External Printer for PMS is connected.
NOTE 5:
When you communicate with CPU built-in modem, be sure to set the data speed of RS1 port
as 4800 bps or more. (1200 bps and 2400 bps are not available.)
NOTE 6:
Set the second data of CM40 Y=07 to "0" when using the cable for PRT.
NOTE 7:
Set the second data of CM40 Y=07 to "1" when using the cable except for PRT.
NOTE 8:
This data should be set to "0" for downloading soft key information from UM8000 to CPU.
CPU RS-232C PORT
PORT LOCATION NUMBER
0 UNIT01 PORT1
1 UNIT01 PORT2
4 UNIT02 PORT1
[8300R2] NOTE 1
5 UNIT02 PORT2
[8300R2] NOTE 1
6 UNIT03 PORT1
[8300R2] NOTE 1
7 UNIT03 PORT2
[8300R2] NOTE 1
0 UNIT01 PORT1
1 UNIT01 PORT2
SETTING DATA
DATA MEANING
0 Low
1 High
0 CS control is always
provided
1 As per CS signal
input
1 1200 bps
2 2400 bps
3 4800 bps
4 9600 bps
5 19200 bps
NONE 9600 bps
0 High
1 Low
3-259
CM40
: Default
REMARKS
NOTE 3
NOTE 6
NOTE 7
NOTE 5
NWA-033623-001 Rev.3.0
91ch3004.fm
NOVEMBER/12/2008