NEC UNIVERGE SV8300 Command Manual page 576

COMMAND CODE TITLE:
E6
Y MEANING
06 Call Forwarding-PS Out of Cell
(Zone)
Call Forwarding-Logout (IP Station)
07 Timing of Call Forwarding-No
Answer for a trunk incoming call on
a station basis
08 Timing of Call Forwarding-No
Answer for an internal call or an
assisted call on a station basis
50 Trunk number link up with a
Mobility Access station number
NOTE 1:
Station number cannot be assigned to second data.
NOTE 2:
When the mobile phone number has been already assigned to other station number, "ASSIGNED
ALREADY" is displayed.
NOTE 3: Outgoing Trunk Access Code (1-4 digits) must be assigned by CM64 Y=10.
NOTE 4: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=51 as the 2nd data.
51 Destination of ISDN Alternative
Routing of in Remote Unit survival
mode (station basis)
NOTE 1: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=50 as the 2nd data.
NOTE 2: When 2nd data of CM64 Y=12 is set to "0", the destination is set by this command.
CALL FORWARDING SET/RESET FROM PCPro/CAT
• Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX +
X-XXXX: Outgoing Trunk Access Code (1-4 digits)
,
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
[8300R2]
NONE
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
• Trunk number=Mobile phone No. (Maximum 26 digits)
NONE
• Destination C.O. line number (Maximum 26 digits)
NONE
DESTINATION
,
+ YY...YY
: Separate Mark
: No data
: As per CM41 Y=0>100
: As per CM41 Y=0>101
: No data
: No data
3-527
CME6
: Default
NWA-033623-001 Rev.3.0
91ch3008.fm
NOVEMBER/12/2008