NEC UNIVERGE SV8300 Command Manual page 85

COMMAND CODE TITLE:
08
155 Whether dialing digit "1" upon encountering trunk busy is
effective as switch hook flash. (For DP telephone)
NOTE: Effective only when CM08>151: 1.
156 Dialing of a Single Digit Feature Access Code while the calling
station hears RBT, or performs a Voice Call
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears RBT.
Access
Code
1 Voice Call
2 Call Back-No Answer Not
6 Message Reminder/
Message Waiting Set
8 Message Waiting
Record
NOTE 1: While the Multiline Terminal or DP telephone is holding the other call, this feature is not available.
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
157 Paging answer by PGD(2)-U10 Station Dialing (only in the
case of Delay and Non-delay answer)
NOTE: The Paging Answer by the following methods is
applied depending on the setting of this command.
- When the second data is set to "0": PGD(2)-U10
station number assigned by CM10 Y=00.
- When the second data is set to "1": Paging Answer
Zone 0-9 assigned by CM20 Y=0-3: A070-A079.
158 All Zone Internal Paging
161 Transfer a trunk line placed in Consultation Hold
(Hold Transfer)
BASIC SERVICES
BASIC SERVICE
Service
Attendant
Console
Available
Available
Available
Available
See CM56 Y=00-07 CM20>A164
0 Effective as switch hook flash
1 Ineffective
0 Available
1 Not available
Calling Station Kind
Multiline DP
Terminal
Telephone
Available Available
Available Available
NOTE 1 NOTE 1
Available Available
Available Available
0 Available
1 Not available
0 Not available
1 Available
0 Available (Hold Transfer)
1 Not available (Consultation Hold)
3-36
: Default
SETTING DATA
DTMF Telephone
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
Available after Hooking
NOTE 2
Continued on next page
NWA-033623-001 Rev.3.0
91ch3001.fm
NOVEMBER/12/2008
CM08