NEC UNIVERGE SV8300 Command Manual page 566

COMMAND CODE TITLE:
D7
Y
No. MEANING
7 Chime from Multiline
Terminal when receiving
RR signal of MSF/TMF
8 Chime from Multiline
Terminal when setting up
TMF
Display of guidance on
Multiline Terminal when
setting up TMF
A AP database of FLF
Chime from Multiline
Terminal at the time ter-
minal mode is released
Chime from Multiline
Terminal when MSF is
canceled
NOTE 1:
OAI Function key number is assigned by CM90.
NOTE 2:
The digit code is assigned by CMD7 Y=6.
NOTE 3:
The maximum number of operation codes is 16.
NOTE 4:
Digit number is assigned by CMD7 Y=0.
NOTE 5:
Do not use * as a digit code.
NOTE 6:
The maximum number of operation codes is 128.
NOTE 7:
Setting data for CMD7 Y=A>01 is effective only when CMD7 Y=A>00: 1.
OAI CONTROL DATA
1ST DATA
DATA
F1032 OAI Function Key No. 0
F1047 OAI Function Key No. 15
00 Chime before sending terminal
messages (when pressing OAI
Function Key)
02 Chime after sending terminal
messages
01 Display of guidance before
sending terminal messages
(when pressing OAI Function
Key)
03 Display of guidance after send-
ing terminal messages
00 Recognition of AP database by
RR message
01 Omission of AP database for
information added to RR mes-
sage
0B Chime sending out at the time
(MRFR, MRFI) terminal mode
release
11 When Terminal Mode is can-
celed
MEANING DATA
NOTE 7
3-517
2ND DATA
MEANING
00 Not sent
01 To send
00 No ring
01 Ring
00 Not displayed
01 To display
0 To provide
1 Not provided
0 Not omitted
1 To omit
0 No ring
1 Ring
0 Ring
1 No ring
NWA-033623-001 Rev.3.0
NOVEMBER/12/2008
CMD7
: Default
91ch3008.fm