NEC UNIVERGE SV8300 Command Manual page 272

COMMAND CODE TITLE:
35
(3) Voice quality improvement of SV8300
When the voice interruption or the echo occurs during calling via SV8300, you need to improve
voice quality by setting PAD control etc.
Control of Intra-office connection PAD (SLT/Mutiline Terminal)
(1) CM13 Y=09 (Intra-office connection PAD)
1st data =X-XXXXXXXX (Station number)
2nd data=1
(2) CM42
1st data =190 (Setting of PAD data for a Station-to-Station call)
2nd data=19 (+3 dB [send]/+3 dB [receive])
Control of PAD data from a trunk to a station (for IPT)
(1) CM35 Y=289 (Intra-office connection PAD)
1st data =00-63 (Trunk route number)
2nd data=NONE
(2) CM35 Y=290 (Setting of PAD data from a station to a trunk)
1st data =00-63 (Trunk route number)
2nd data=NONE
NOTE:
This data must be set to default data.
Control of PAD data from a trunk to a station (for analog trunk)
(1) CM35 Y=289 (Intra-office connection PAD)
1st data=00-63 (Trunk route number)
2nd data: see below
2ND DATA
07 9 dB loss
13 3 dB loss
TRUNK ROUTE DATA
(Available [As per CM42>190])
NOTE
(0 dB loss)
NOTE
(0 dB loss)
Set this data when connecting to the behind PBX (digital) or using 2W E&M
(tie line) if the distance from PSTN is extremely near (however, when the atten-
uation of voice levels is large, such as cascade connection of PBXs, set the
second data to "13" (3 dB)).
4w tie line
RECITAL
3-223
CM35
NWA-033623-001 Rev.3.0
91ch3003.fm
NOVEMBER/12/2008