Cat Mode Setting Procedure - NEC UNIVERGE SV8300 Command Manual

CAT MODE SETTING PROCEDURE

To set CAT mode:
• For DT300/DT700 Series/D
1. Press the Keys on the terminal in the following order when the terminal is on idle state.
2 2 8
"C" "A" "T"
2. Press
Hold
– "CAT MODE" is displayed on LCD
NOTE:
CAT mode is not available when preset dialing on the terminal is restricted (set by CM15
Y=212: 0).
term
• For D 70 (Elite)/D
1. Press
Transfer
2. Press
Conf
– Conf lamp flashes
3. Press
*
– Conf lamp off
4. Press
Transfer
NOTE:
Step 1 through 6 need to be completed within 4 seconds.
term
70 (Elite)/D
6 6 3 3
"M" "O" "D" "E"
term term
75 (Series E)/D
term term
75 (Series E)/D
#
85 (Series i)
5. Press
Conf
– Conf lamp flashes
6. Press
#
– Conf, Speaker, Answer lamp on
– "CAT MODE" is displayed on LCD
7. Press
ST
– "COMMAND= –" is displayed on LCD
1-8
Chapter 1 HOW TO USE CAT
CAT MODE SETTING PROCEDURE
85 (Series i)
NWA-033623-001 Rev.3.0
NOVEMBER/12/2008
91ch1001.fm