NEC UNIVERGE SV8300 Command Manual page 416

COMMAND CODE TITLE:
67
Y
No. MEANING
06 Diffserv Code
Point (DSCP) of
control packet and
voice packet
NOTE 1:
This data is required when the system is connected to the router that provides the Diffserv type QoS
function.
NOTE 2:
This data setting is valid to the packets that are sent to the location which is set "ZZ" in the first data
from the location which is set to "XX" in the first data.
NOTE 3: The TOS field precedence that is set by CM67 Y=01 is invalid when this data is set. To be valid the
TOS field precedence, set CM67 Y=01 again after this data setting.
07 Whether the IP
Station at remote
unit location from
IPS through NAT
can communicate
with each other
under the same
NAT or not
NOTE:
The same location number must not be assigned to IP Station that is not accommodated under the same
NAT. However, multiple location numbers can be assigned to IP Station that is accommodated under
the same NAT.
08 Whether the con-
nection between
locations is
restricted or not
NOTE:
Restrict the following connection by this command when NAT is used.
-Connection via CCIS (Peer to Peer connection)
-Connection between Main Unit and Remote Units
-Connection between locations that are restricted the communications
LOCATION DATA ASSIGNMENT
1ST DATA
DATA MEANING
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
XX ZZ XX: Location
number
(00-63)
ZZ : Location
number
(00-63)
2ND DATA
DATA MEANING
XX ZZ XX: 00-FE: DSCP of
control packet
ZZ : 00-FE: DSCP of
voice packet
NONE C0A0
0 Under the same NAT
1 Under the different NAT
or Not used NAT
0 To restrict
1 Not restrict
3-367
CM67
: Default
RELATED
COMMAND
CM12 Y=39/50
CM8A Y=5000-
5255: 173
CM67 Y=01
CM67 Y=08
CM67 Y=07
Continued on next page
NWA-033623-001 Rev.3.0
91ch3005.fm
NOVEMBER/12/2008