NEC UNIVERGE SV8300 Command Manual page 297

COMMAND CODE TITLE:
35
Y
No. MEANING
233 Release of ISDN trunk when
receiving the ISDN DIS-
CONNECT message with
Progress Description=08
from ISDN because the
called party is busy in tan-
dem connection (ISDN to
ISDN)
NOTE 1:
To release the ISDN trunk when receiving the ISDN DISCONNECT message, set the second data 0 to
the incoming trunk route of tandem office.
NOTE 2:
Assign the second data 0 to the incoming and forwarding trunk route of Mobility Access.
234 Type of number/Numbering
plan identification of ISDN
Calling Party Number
244 Dial Tone (DT) sending to
calling party of opposite
office when receiving the
SETUP message by Overlap
Receiving-Q-SIG
[Russia Only]
NOTE 1: This command can be also used to specify whether the SETUP message does not contain a called par-
ty number is enabled or not.
When the SETUP message does not contain a called party number message is not enabled, assign the
second data to "0".
NOTE 2: This command should be assigned to incoming trunk route when sending DT to calling party.
NOTE 3: This command should be assigned to both incoming trunk route and outgoing trunk route when the
SETUP message does not contain a called party number is not enabled.
245 Calling Party number (1-8
digits) transfer to ISDN on
tandem call from Q-SIG
247 Forced release in designated
time for outgoing trunk route
TRUNK ROUTE DATA
DATA
0 To release
1 Not released
0 To provide
1 Not provided
0 To send DT of own office
1 Not sent
0 To provide
1 Not provided
0 To provide
1 Not provided
SETTING DATA
MEANING
3-248
CM35
: Default
RELATED
COMMAND
CM35
Y=266, 158, 208
CM35 Y=230, 231
Continued on next page
NWA-033623-001 Rev.3.0
91ch3003.fm
JULY/18/2008