[Cmac] Isdn Functions - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
AC
FUNCTION:
This command is used to assign the functions to the BRT blade.
PRECAUTION:
This command requires system reset after data setting.
ASSIGNMENT PROCEDURE:
ST + DE
ACYY +
DE
ST +
AC30 +
SPID
+ EXE
(4 digits)
DATA TABLE:
Y
No. MEANING
00 ISDN Line station number to be con-
trolled
01 Layer 2 data link
03 Passive Bus in Point-to-Multipoint con-
nection
06 Checking of TEI (Terminal End-point
Identifier) when Layer 2 data link is
released
10 National ISDN-1 mode
[North America Only]
11 Sending of expanded information on
Low Layer Compatibility (LLC) infor-
mation element for connection between
ISDN telephone/ISDN trunks
ISDN FUNCTIONS
ISDN
+ D-CHANNEL No.
(00-31)
TRUNK BLADE No.
+
(000-127)
XXXXXXXX
ISDN
+ MULTIPOINT No. +
(0-7)
ISDN
+ MULTIPOINT No.
(0-7)
SETTING DATA
DATA MEANING
X ISDN Line station number
0 Point-to-Point connection
1 Point-to-Multipoint connection
0 Extended Passive Bus
1 Short Passive Bus
0 To provide
1 Not provided
0 To provide
1 Not provided
0 Allow
1 Restricted
3-474
DATA
DE
+ +
(1-8 digits)
ISDN
DE
SUBSCRIBER No. +
+ +
(4 digits)
RELATED
COMMAND
CM08>722
CM35 Y=130
Continued on next page
NWA-033623-001 Rev.3.0
CMAC
RESET
EXE
: Default
91ch3007.fm