ABB ACS355 series User Manual page 118

118 Application macros
The AC500 Modbus application macro default values for the drive parameters
correspond to the ABB standard macro (parameter 9902, value 1
see section ABB standard macro
No. Name
1001 EXT1 COMMANDS
1102 EXT1/EXT2 SEL
1103 REF1 SELECT
1604 FAULT RESET SEL
2201 ACC/DEC 1/2 SEL
3018 COMM FAULT FUNC
5302 EFB STATION ID
5303 EFB BAUD RATE
5304 EFB PARITY
5305 EFB CTRL PROFILE
5310 EFB PAR 10
5311 EFB PAR 11
5312 EFB PAR 12
9802 COMM PROT SEL
Note: The default slave address of the drive is 2 (parameter
but if several drives are used, the address must be unique for each drive.
For more information regarding the Starter kit configuration, please refer to
AC500-eCo and ACS355 quick installation guide (2CDC125145M0201 [English]),
and ACS355 and AC500-eCo application guide (2CDC125152M0201 [English]).
on page 110), with the following differences:
Default value
10 (COMM)
8 (COMM)
8 (COMM)
8 (COMM)
0 (NOT SEL)
1 (FAULT)
2
192 (19.2 kb/s)
1 (8 NONE 1)
2 (ABB DRV FULL)
101
303
305
1 (STD MODBUS)
(ABB STANDARD),
5303 EFB STATION ID),