Output Mode - ABB ACS355 series User Manual

80 Control panels
How to change the direction of the motor rotation
You can change the direction of the motor rotation in any mode.
Step Action
1. If the drive is in remote control (REM shown on the
left), switch to local control by pressing
display briefly shows message "LoC" before
returning to the previous display.
2. To change the direction from forward (FWD shown at
the bottom) to reverse (REV shown at the bottom), or
vice versa, press
Note: Parameter
(REQUEST).


Output mode

In the Output mode, you can:
• monitor actual values of up to three group
signal at a time
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
the bottom.
The display shows the value of one group
OPERATING DATA
right. Page 83 tells how to select up to three signals to
be monitored in the Output mode. The table below
shows how to view them one at a time.
How to browse the monitored signals
Step Action
1. If more than one signals have been selected to be
monitored (see page 83), you can browse them in
the Output mode.
To browse the signals forward, press key
repeatedly. To browse them backward, press key
repeatedly.
.
1003 DIRECTION
signal. The unit is shown on the
LOC
. The
LOC
REM
OUTPUT
LOC
OUTPUT
must be set to 3
01 OPERATING DATA
until the display shows text OUTPUT at
01
REM
OUTPUT
REM
OUTPUT
REM
OUTPUT
REM
OUTPUT
Display
491
.
Hz
FWD
491
.
Hz
REV
signals, one
491
.
Hz
FWD
Display
491
.
Hz
FWD
05
A
.
FWD
107
.
%
FWD