ABB ACS355 series User Manual page 288

288 Actual signals and parameters
All parameters
No. Name/Value
RS-485
5102 FB PAR 2
... ...
5126 FB PAR 26
5127 FBA PAR
REFRESH
DONE
REFRESH
5128 FILE CPI FW
REV
0000...FFFF
hex
5129 FILE CONFIG
ID
0000...FFFF
hex
5130 FILE CONFIG
REV
0000...FFFF
hex
5131 FBA STATUS
IDLE
EXECUT INIT
TIME OUT
CONFIG
ERROR
OFF-LINE
ON-LINE
RESET
Description
FSCA-01 RS-485 adapter module
These parameters are adapter module-specific. For more
information, see the module manual. Note that not all of
these parameters are necessarily visible.
Validates any changed adapter module configuration
parameter settings. After refreshing, the value reverts
automatically to DONE.
Refreshing done
Refreshing
Displays the parameter table revision of the fieldbus adapter
module mapping file stored in the memory of the drive.
Format is xyz where:
• x = major revision number
• y = minor revision number
• x = correction letter.
Parameter table revision
Displays the drive type code of the fieldbus adapter module
mapping file stored in the memory of the drive.
Drive type code of fieldbus adapter module mapping file
Displays the fieldbus adapter module mapping file revision
stored in the memory of the drive in decimal format.
Example: 1 = revision 1.
Mapping file revision
Displays the status of the fieldbus adapter module
communication.
Adapter is not configured.
Adapter is initializing.
A time-out has occurred in the communication between the
adapter and the drive.
Adapter configuration error: The major or minor revision
code of the common program revision in the fieldbus
adapter module is not the revision required by the module
(see parameter 5132 FBA CPI FW
upload has failed more than three times.
Adapter is off-line.
Adapter is on-line.
Adapter is performing a hardware reset.
REV) or mapping file
Def/FbEq
485
0
1
1 = 1
1 = 1
1 = 1
0
1
2
3
4
5
6