ABB ACS355 series User Manual page 225

All parameters
No. Name/Value
COMM
EXT2
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
2015 MIN TORQUE
1
-600.0...0.0%
2016 MIN TORQUE
2
-600.0...0.0%
2017 MAX TORQUE
1
0.0...600.0%
2018 MAX TORQUE
2
0.0...600.0%
Description
Fieldbus interface as the source for the torque limit 1/2
selection, ie, Control word
The Control word is sent by the fieldbus controller through
the fieldbus adapter or embedded fieldbus (Modbus) to the
drive. For the Control word bits, see section
communication profile
Maximum torque limit 1 is defined by parameter
TORQUE 1 and maximum torque limit 2 is defined by
parameter 2018 MAX TORQUE
Note: This setting applies only for the DCU profile.
Value of signal 0112 EXTERNAL REF 2
Inverted digital input DI1. 1 = parameter
TORQUE 1 value. 0 = parameter
value.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Defines minimum torque limit 1 for the drive. See parameter
2013 MIN TORQUE
Value as a percentage of the motor nominal torque
Defines minimum torque limit 2 for the drive. See parameter
2013 MIN TORQUE
Value as a percentage of the motor nominal torque
Defines maximum torque limit 1 for the drive. See
parameter 2014 MAX TORQUE
Value as a percentage of the motor nominal torque
Defines maximum torque limit 2 for the drive. See
parameter 2014 MAX TORQUE
Value as a percentage of the motor nominal torque
Actual signals and parameters 225
0301 FB CMD WORD 1
on page 333.
2.
2017 MAX
2018 MAX TORQUE 2
SEL.
SEL.
SEL.
SEL.
Def/FbEq
7
bit 15.
DCU
2017 MAX
11
-1
-2
-3
-4
-5
-300%
1 = 0.1%
-300%
1 = 0.1%
300%
1 = 0.1%
300%
1 = 0.1%