ABB ACS355 series User Manual page 79

How to find out the panel firmware version
Step Action
1. If the power is switched on, switch it off.
2. Keep key
power and read the panel firmware version shown on
the display.
When you release the
Output mode.
How to start, stop and switch between local and remote control
You can start, stop and switch between local and remote control in any mode. To be
able to start or stop the drive, the drive must be in local control.
Step Action
1. • To switch between remote control (REM shown on
the left) and local control (LOC shown on the left),
press .
LOC
REM
Note: Switching to local control can be disabled
with parameter
After pressing the key, the display briefly shows
message "LoC" or "rE", as appropriate, before
returning to the previous display.
The very first time the drive is powered up, it is in
remote control (REM) and controlled through the
drive I/O terminals. To switch to local control (LOC)
and control the drive using the control panel, press
. The result depends on how long you press
LOC
REM
the key:
• If you release the key immediately (the display
flashes "LoC"), the drive stops. Set the local
control reference as instructed on page 81.
• If you press the key for about two seconds
(release when the display changes from "LoC"
to "LoC r"), the drive continues as before. The
drive copies the current remote values for the
run/stop status and the reference, and uses
them as the initial local control settings.
• To stop the drive in local control, press
• To start the drive in local control, press
pressed down while you switch on the
key, the panel goes to the
1606 LOCAL LOCK.
Control panels 79
Display
X X X
Display
LOC
OUTPUT
LoC
LOC
. Text FWD or REV on the bottom
line starts flashing slowly.
. Text FWD or REV on the bottom
line starts flashing rapidly. It
stops flashing when the drive
reaches the setpoint.
.
491
.
Hz
FWD
FWD