ABB ACS355 series User Manual page 212

212 Actual signals and parameters
All parameters
No. Name/Value
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI1,2(INV)
DI2,3(INV)
DI3,4(INV)
DI4,5(INV)
1606 LOCAL LOCK
NOT SEL
DI1
DI2
DI3
DI4
DI5
ON
COMM
DI1(INV)
DI2(INV)
DI3(INV)
Description
User parameter set control through inverted digital input
DI1. Falling edge of inverted digital input DI1: User
parameter set 2 is loaded into use. Rising edge of inverted
digital input DI1: User parameter set 1 is loaded into use.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
User parameter set selection through inverted digital inputs
DI1 and DI2. 1 = DI inactive, 0 =DI active.
DI1 DI2 User parameter set
1 1 User parameter set 1
0 1 User parameter set 2
1 0 User parameter set 3
See selection DI1,2.
See selection DI1,2.
See selection DI1,2.
Disables entering local control mode or selects the source
for the local control mode lock signal. When local lock is
active, entering the local control mode is disabled
(LOC/REM key of the panel).
Local control is allowed.
Local control mode lock signal through digital input DI1.
Rising edge of digital input DI1: Local control disabled.
Falling edge of digital input DI1: Local control allowed.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Local control is disabled.
Fieldbus interface as the source for the local lock, ie,
Control word 0301 FB CMD WORD 1
word is sent by the fieldbus controller through the fieldbus
adapter or embedded fieldbus (Modbus) to the drive. For
the Control word bits, see section
profile on page 333.
Note: This setting applies only for the DCU profile.
Local lock through inverted digital input DI1. Rising edge of
inverted digital input DI1: Local control allowed. Falling edge
of inverted digital input DI1: Local control disabled.
See selection DI1(INV).
See selection DI1(INV).
bit 14. The Control
DCU communication
Def/FbEq
-1
-2
-3
-4
-7
-8
-9
-10
NOT SEL
0
1
2
3
4
5
7
8
-1
-2
-3