Ext Comm Module - ABB ACS355 series User Manual

All parameters
No. Name/Value
5002 ENCODER
ENABLE
DISABLE
ENABLE
5003 ENCODER
FAULT
FAULT
ALARM
5010 Z PLS ENABLE Enables the encoder zero (Z) pulse. Zero pulse is used for
DISABLE
ENABLE
5011 POSITION
RESET
DISABLE
ENABLE
51 EXT COMM
MODULE
5101 FBA TYPE
NOT_DEFINE
D
PROFIBUS_D
P
LONWORKS
CANOPEN
DEVICENET
CONTROLNET FCNA-01 ControlNet adapter module
ETHERNET
ETHERCAT
ETHERN_PO
WERLINK
Description
Enables the encoder.
Disabled
Enabled
Defines the operation of the drive if a failure is detected in
communication between the pulse encoder and the pulse
encoder interface module, or between the module and the
drive.
The drive trips on fault
The drive generates alarm
position reset.
Disabled
Enabled
Enables the position reset.
Disabled
Enabled
The parameters need to be adjusted only when a fieldbus
adapter module (optional) is installed and activated by
parameter 9802 COMM PROT
parameters, refer to the manual of the fieldbus module and
chapter Fieldbus control with fieldbus adapter
These parameter settings will remain the same even though
the macro is changed.
Note: In adapter module the parameter group number is 1.
Displays the type of the connected fieldbus adapter module.
Fieldbus module is not found, or it is not properly
connected, or parameter
not EXT FBA.
FPBA-01 PROFIBUS DP adapter module, FPBA-01-M
PROFIBUS DP adapter module
FLON-01 L W
ON ORKS
FCAN-01 CANopen adapter module, FCAN-01-M CANopen
adapter module
FDNA-01 DeviceNet adapter module
FENA-01/-11/-21 Ethernet adapter module
FECA-01 EtherCAT adapter module
FEPL-02 Ethernet POWERLINK adapter module
Actual signals and parameters 287
ENCODER ERR (0023).
ENCODER ERROR
SEL. For more details on the
9802 COMM PROT SEL
® adapter module
Def/FbEq
DISABLE
0
1
FAULT
1
(2024). 2
DISABLE
0
1
DISABLE
0
1
on page 339.
0
setting is
1
21
32
37
101
128
135
136