Operation - ABB ACS355 series User Manual

88 Control panels
Status line
The top line of the LCD display shows the basic status information of the drive.
LOC
1 2
No. Field
1 Control location
2 State
3 Panel operation
mode
4 Reference value or
number of the
selected item


Operation

You operate the control panel with menus and keys. The keys include two context-
sensitive soft keys, whose current function is indicated by the text shown in the
display above each key.
You select an option, eg, operation mode or parameter, by scrolling the
arrow keys until the option is highlighted (in reverse video) and then pressing
the relevant soft key. With the right soft key
option or save the changes. The left soft key
and return to the previous operation level.
The assistant control panel has nine panel modes:
Assistants mode, Changed parameters
mode, Parameter backup
the first eight modes is described in this chapter. When a fault or alarm occurs, the
panel goes automatically to the Fault mode showing the fault or alarm. You can reset
it in the Output or Fault mode (see chapter
49.1Hz
4
Alternatives
LOC
REM
Rotating arrow
Dotted rotating arrow
Stationary arrow
Dotted stationary arrow
mode,
mode, I/O settings mode
LOC MAIN MENU
1 2 3
Significance
Drive control is local, that is, from the
control panel.
Drive control is remote, such as the drive
I/O or fieldbus.
Forward shaft direction
Reverse shaft direction
Drive is running at setpoint.
Drive is running but not at setpoint.
Drive is stopped.
Start command is present, but the motor is
not running, eg, because start enable is
missing.
• Name of the current mode
• Name of the list or menu shown
• Name of the operation state, eg, PAR
EDIT.
• Reference value in the Output mode
• Number of the highlighted item, eg,
mode, parameter group or fault.
you usually enter a mode, accept an
is used to cancel the made changes
Output mode,
Fault logger mode,
and Fault mode. The operation in
Fault tracing on page 349).
1
4
and
Parameter mode,
Time and date