ABB ACS355 series User Manual page 249

All parameters
No. Name/Value
3002 PANEL COMM
ERR
FAULT
CONST SP 7
LAST SPEED
3003 EXTERNAL
FAULT 1
NOT SEL
DI1
DI2
DI3
DI4
DI5
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
3004 EXTERNAL
FAULT 2
Description
Selects how the drive reacts to a control panel
communication break.
Note: When either of the two external control locations are
active, and start, stop and/or direction are through the
control panel – 1001 EXT1 COMMANDS
COMMANDS = 8 (KEYPAD) – the drive follows the speed
reference according to the configuration of the external
control locations, instead of the value of the last speed or
parameter 1208 CONST SPEED
Drive trips on fault PANEL LOSS
coasts to stop.
The drive generates alarm
the speed to the speed defined by parameter
SPEED 7.
WARNING! Make sure that it is safe to continue
operation in case of a panel communication break.
The drive generates alarm
freezes the speed to the level the drive was operating at.
The speed is determined by the average speed over the
previous 10 seconds.
WARNING! Make sure that it is safe to continue
operation in case of a panel communication break.
Selects an interface for an external fault 1 signal.
Not selected
External fault indication through digital input DI1.
1 = Fault trip on EXT FAULT 1
0 = No external fault.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
External fault indication through inverted digital input DI1.
0 = Fault trip on EXT FAULT 1
1 = No external fault.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Selects an interface for an external fault 2 signal.
See parameter 3003 EXTERNAL FAULT
Actual signals and parameters 249
/ 1002 EXT2
7.
(0010) and the motor
PANEL LOSS (2008) and sets
1208 CONST
PANEL LOSS (2008) and
(0014). Motor coasts to stop.
(0014). Motor coasts to stop.
1.
Def/FbEq
FAULT
1
2
3
NOT SEL
0
1
2
3
4
5
-1
-2
-3
-4
-5
NOT SEL