Operation - ABB ACS355 series User Manual

78 Control panels


Operation

You operate the control panel with the help of menus and keys. You select an option,
eg, operation mode or parameter, by scrolling the
option is visible in the display and then pressing the
With the key, you return to the previous operation level without saving the made
changes.
The basic control panel has five panel modes:
Parameter mode, Copy mode
is described in this chapter. When a fault or alarm occurs, the panel goes
automatically to the Fault mode showing the fault or alarm code. You can reset the
fault or alarm in the Output or Fault mode (see chapter
After the power is switched on, the panel is in the
Output mode, where you can start, stop, change the
direction, switch between local and remote control and
monitor up to three actual values (one at a time). To do
other tasks, go first to the Main menu and select the
appropriate mode.
How to do common tasks
The table below lists common tasks, the mode in which you can perform them and the page
number where the steps to do the task are described in detail.
Task
How to find out the panel firmware version
How to switch between local and remote control
How to start and stop the drive
How to change the direction of the motor rotation
How to browse the monitored signals
How to set the speed, frequency or torque reference
How to change the value of a parameter
How to select the monitored signals
How to reset faults and alarms
How to copy parameters from the drive to the control panel
How to restore parameters from the control panel to the drive
Output
and Fault mode. The operation in the first four modes
and arrow keys until the
key.
mode, Reference mode,
Fault tracing on page 349).
491
REM
OUTPUT
PAr
REM
MENU
Mode
At power up
Any
Any
Any
Output
Reference
Parameter
Parameter
Output, Fault
Copy
Copy
.
Hz
FWD
FWD
Page
79
79
79
80
80
81
82
83
349
85
85