ABB ACS355 series User Manual page 224

224 Actual signals and parameters
All parameters
No. Name/Value
DI2
DI3
DI4
DI5
COMM
EXT2
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
2014 MAX TORQUE
SEL
MAX TORQUE
1
DI1
DI2
DI3
DI4
DI5
Description
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Fieldbus interface as the source for the torque limit 1/2
selection, ie, Control word
The Control word is sent by the fieldbus controller through
the fieldbus adapter or embedded fieldbus (Modbus) to the
drive. For the Control word bits, see section
communication profile
Minimum torque limit 1 is defined by parameter
TORQUE 1 and minimum torque limit 2 is defined by
parameter 2016 MIN TORQUE
Note: This setting applies only for the DCU profile.
Value of signal 0112 EXTERNAL REF 2
Inverted digital input DI1. 1 = value of parameter
TORQUE 1 1. 0 = value of parameter
2.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Selects the maximum torque limit for the drive.
Value of parameter 2017 MAX TORQUE 1
Digital input DI1. 0 = parameter
value. 1 = parameter
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
0301 FB CMD WORD 1
on page 333.
2.
2016 MIN TORQUE
2017 MAX TORQUE 1
2018 MAX TORQUE 2
Def/FbEq
2
3
4
5
7
bit 15.
DCU
2015 MIN
11
2015 MIN -1
-2
-3
-4
-5
MAX
TORQUE
1
1
value.
2
3
4
5