ABB ACS355 series User Manual page 364

364 Fault tracing
CODE FAULT
0101 SERF CORRUPT
(FF55)
0307 bit 14
0103 SERF MACRO
(FF55)
0307 bit 14
0201 DSP T1
OVERLOAD
(6100)
0307 bit 13
0202 DSP T2
OVERLOAD
(6100)
0307 bit 13
0203 DSP T3
OVERLOAD
(6100)
0307 bit 13
0204 DSP STACK
ERROR
(6100)
0307 bit 12
0206 CB ID ERROR
(5000)
0307 bit 11
1000 PAR HZRPM
(6320)
0307 bit 15
1003 PAR AI SCALE
(6320)
0307 bit 15
CAUSE
Drive internal error.
Drive internal error.
Drive internal error.
Incorrect
speed/frequency limit
parameter setting
Incorrect analog input AI
signal scaling
WHAT TO DO
Replace the drive.
If fieldbus is in use, check the
communication, settings and contacts.
Write down fault code and contact
your local ABB representative.
Replace the drive.
Check parameter settings. Check that
following applies:
• 2001 MINIMUM SPEED
2002 MAXIMUM SPEED
• 2007 MINIMUM FREQ
2008 MAXIMUM FREQ
• 2001 MINIMUM SPEED
9908 MOTOR NOM
2002 MAXIMUM SPEED
9908 MOTOR NOM
2007 MINIMUM FREQ
9907 MOTOR NOM FREQ
2008 MAXIMUM FREQ
9907 MOTOR NOM FREQ
within range.
Check parameter group
INPUTS settings. Check that following
applies:
• 1301 MINIMUM AI1
1302 MAXIMUM AI1
• 1304 MINIMUM AI2
1305 MAXIMUM AI2.
<
<
/
SPEED,
/
SPEED,
/
and
/
are
13 ANALOG
<
<