Assistants Mode - ABB ACS355 series User Manual

96 Control panels


Assistants mode

When the drive is first powered up, the Start-up assistant guides you through the
setup of the basic parameters. The Start-up assistant is divided into assistants, each
of which is responsible for the specification of a related parameter set, for example
Motor set-up or PID control. The Start-up assistant activates the assistants one after
the other. You may also use the assistants independently. For more information on
the tasks of the assistants, see section
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.
How to use an assistant
The table below shows the basic operation sequence which leads you through
assistants. The Motor set-up assistant is used as an example.
Step Action
1. Go to the Main menu by pressing
Output mode, otherwise by pressing repeatedly
you get to the Main menu.
2. Go to the Assistants mode by selecting ASSISTANTS on
the menu keys
3. Select the assistant with keys
SEL
press .
If you select any other assistant than the Start-up
assistant, it guides you through the task of specification
of its parameter set as shown in steps
After that you can select another assistant on the
Assistants menu or exit the Assistants mode. The Motor
set-up assistant is used here as an example.
If you select the Start-up assistant, it activates the first
assistant, which guides you through the task of
specification of its parameter set as shown in steps
and 5. below. The Start-up assistant then asks if you
want to continue with the next assistant or skip it – select
the appropriate answer with keys
SEL
press . If you choose to skip, the Start-up assistant
asks the same question about the next assistant, and so
on.
Start-up assistant
MENU
if you are in the
and , and pressing
and
4. and
and
on page 121.
LOC
EXIT
until PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
LOC
ENTER
.
Start-up assistant
Motor Set-up
Application
Speed control EXT1
Speed control EXT2
EXIT
, and
LOC
9905 MOTOR NOM VOLT
5. below.
EXIT
LOC
Do you want to
continue with
4.
application setup?
Continue
Skip
, and EXIT
Display
MAIN MENU 1
00:00
ENTER
ASSISTANTS 1
00:00
SEL
PAR EDIT
200 V
00:00 SAVE
CHOICE
00:00
OK