Siemens SINUMERIK 840D sl Function Manual page 391

37907
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
37908
MD number
Default value: 0
Change becomes effective after: POWER ON
Data type: DWORD
Meaning:
Special cases, errors,...
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_2[0...14]
Output assignment, cam range bit for cam track 2
Min. input limit: 0
This machine data specifies the outputs for the cam range bits of cam track 2.
Structure: see $MA_SAFE_SVSS_STATUS_OUTPUT
Field index n corresponds to the parameterizable cam range numbers on cam track 2.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam that
is assigned to cam track 2 by parameterizing the cam range number 5.
Note:
The "Safe Cam Track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 2 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be parameterized.
$MA_SAFE_CAM_RANGE_BIN_OUTPUT_3[0...14]
Output assignment, cam range bit for cam track 3
Min. input limit: 0
This machine data specifies the outputs for the cam range bits of cam track 3.
Structure: see $MA_SAFE_SVSS_STATUS_OUTPUT
Field index n corresponds to the parameterizable cam range numbers on cam track 3.
The cam range number is defined using the following machine data:
MD36938 $MA_SAFE_CAM_TRACK_ASSIGN[0...29]
Signal means
= 0, axis is not located on the cam with cam range number n
= 1, axis is located on the cam with cam range number n
Example:
The signal that is addressed using field index 5 goes to 1 if the axis is located at the cam that
is assigned to cam track 3 by parameterizing the cam range number 5.
Note:
The "Safe Cam Track" function is enabled using MD36903 $MA_SAFE_CAM_ENABLE.
If the cam range number n is not parameterized on cam track 3 then the signal of field index
n can never go to 1. The output MD with field index n must in this case not be parameterized.
9.1 Machine data for SINUMERIK 840D sl
Protection level: 7/2
Protection level: 7/2
Data descriptions
Max. input limit: 84020620
Unit: -
Max. input limit: 84020620
Unit: -
391