Siemens SINUMERIK 840D sl Function Manual page 463

r9895 SI diagnostics, STOP F (Motor Module)
Displays the number of the cross-checked data, which has caused STOP F on the
Motor Module/Hydraulic Module.
See also: r9795 and F30611
The complete list of numbers for the crosswise compared data is listed in fault
F30611.
Unit: Default value:
- -
p9897 SI Motion bus failure STO delay time (Motor Module)
Sets the delay time for STO after bus failure on the Motor Module/Hydraulic Module
(e.g. used for ESR).
This parameter is overwritten by the copy function of the safety functions integrated
in the drive.
Rounding-off effects can occur in the last decimal places of the parameterized
time. The set time is internally rounded off to an integer multiple of the monitoring
clock cycle (p9500/p9300).
Unit: Default value:
μs 0
r9898 SI actual checksum SI parameters (Motor Module)
Displays the checksum for the checked Safety Integrated parameters on the Motor
Module/Hydraulic Module (actual checksum).
See also: r9798, p9899
Unit: Default value:
- -
p9899 SI reference checksum SI parameters (Motor Module)
Sets the checksum for the checked Safety Integrated parameters on the Motor
Module/Hydraulic Module (reference checksum).
See also: p9799, r9898
Unit: Default value:
- 0000 hex
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
Minimum value: Maximum value:
- -
Minimum value: Maximum value:
0 800000
Minimum value: Maximum value:
- -
Minimum value: Maximum value:
0000 hex FFFFFFFF hex
Data descriptions
9.2 Parameters for SINAMICS S120
Checksum: Protection level:
No 2
Data type: Effectiveness:
Unsigned32 -
Checksum: Protection level:
Yes 3
Data type: Effectiveness:
Real32 When exiting the
SI commissioning
mode
Checksum: Protection level:
No 3
Data type: Effectiveness:
Unsigned32 -
Checksum: Protection level:
No 3
Data type: Effectiveness:
Unsigned32 When exiting the
SI commissioning
mode
463