Siemens SINUMERIK 840D sl Function Manual page 547

Note
The template in the toolbox is only a recommendation.
An electronic template for the acceptance report is available:
● in the toolbox for SINUMERIK 840D sl
● on DOConCD for SINUMERIK 840D sl
● on the service CD for SINUMERIK 840D sl
The acceptance report is divided into the following sections:
● Plant/system description
● Description of the safety functions
● Test of safety functions
Effect of the acceptance test for specific measures
Table 10-1 Recommendations for the scope of the acceptance test depending on specific measures
Measure Documentation
Replace the en‐ Inclusion of hard‐
coder system ware data
(see "Replacing a
motor or encoder
(Page 557)")
Replace an SMC, Inclusion of hard‐
SME module ware data/ soft‐
ware version data
(see "Replacing a
motor or encoder
(Page 557)")
Replacing a motor Inclusion of hard‐
equipped with ware data/ soft‐
DRIVE-CLiQ ware version data
(see "Replacing a
motor or encoder
(Page 557)")
Replacing a Motor Inclusion of hard‐
Module ware data/ soft‐
ware version data
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
Function test Function test
Part 1
No No
No No
No No
Yes, only Points No
2.1 and 2.2
Supplementary
measures
Part 2
Point 4.1
Point 4.1
Point 4.1
Point 4.1
Commissioning
10.6 Acceptance test
Completion of the
report
Document the
modified check‐
sum. From soft‐
ware release 4.5
SP6, the modified
checksum is docu‐
mented in the log
file.
Document the
modified check‐
sum. From soft‐
ware release 4.5
SP6, the modified
checksum is docu‐
mented in the log
file.
Document the
modified check‐
sum. From soft‐
ware release 4.5
SP6, the modified
checksum is docu‐
mented in the log
file.
No
547