Siemens SINUMERIK 840D sl Operating Manual page 153

Information on the System variables·can be found in the System variables for the Package
configuration dialog (Page 372) section.
Further general information on the system variables can be found in the Reference list system
variables (Page 368) section.
Dialog
You can define the general properties for "Dialog" centrally for all dialogs. Detailed information
can be found in the Overview "Defining general properties for all dialogs (Page 142)" section.
However, you can also individually adapt the "Dialog" properties for each dialog page, which
then take effect when the package is executed:
Table 4-16
Activation
Editing mode
Display messages
Information text
Package configuration
The following properties are available:
Table 4-17
List
Preselection
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
"Dialogs" tab > "Dialog" property group
Yes
No
Manual
Automatic
Progress
Error
Errors and
warnings
All
Package configuration
Here, you specify whether the dialog page is to be used for the
package execution.
If this is not activated for the package execution, the following
properties have no effect.
The dialog page is completely displayed, the operator can
make changes and must trigger the dialog page advance or
execution.
The dialog page is completely displayed and executed auto‐
matically.
The operator cannot make any changes.
Processing is analogous to the "Automatic" mode without the
configuration information being displayed.
A progress indicator is displayed in a small display window.
The "Display messages" property specifies which messages
for the 840D or CMC system are displayed during the package
execution. Messages to be suppressed are acknowledged via
the automatic actuation of the standard button.
Messages and dialogs from the (Error, Warning, Msg, Input...)
script are always displayed.
Clicking the button opens the "Information text" dialog where
you can insert a text with notes for the operation.
Formatting with the QT-supported HTML subset is possible.
The list of all existing package configurations in the package is
displayed in the "List of package configurations" dialog.
Here, you make the selection for the selected package config‐
uration for package execution.
Create MyConfig - Expert
4.4 Project folder
153