Modifying Installed Program Parts - Siemens SINUMERIK 840D sl Operating Manual

setup.exe /W /L1031 /V"commandline=\"\"\"-OF:D:\mySetupConfiguration
\OPFILE.txt\"\"\""
2.2.3

Modifying installed program parts

The program components Diff, Topo, Expert and Samples can be subsequently individually
added - or removed if they had been installed.
There are three versions:
Version 1
1. In the Windows Control panel, select "Programs and functions".
2. Select "Create MyConfig", and then click on "Change".
3. Select the program parts that you wish to add or remove.
Version 2
● Start the ""setup.exe"" file again on the DVD.
– You then go to the same dialogs - and you can proceed as for version 1.
– The precondition is that the same "setup.exe" is used as was used to install the version.
Version 3
● Use control file "OPFILE.txt (Page 15)" to subsequently add or delete program components.
If, for features, you specify another configuration, then precisely this is installed.
– If you have already installed "Topo," and you also wish to install "Diff," the "Features"
– If only want to install Diff instead of the installed Topo, then the "Features" parameter
These three versions can be combined. For example, this means you can first use version 1,
for a subsequent change, version 3, and later, for a new change, version 2.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
parameter looks like this:
Features=Topo,Diff
looks like this:
Features=Diff
Installation
2.2 Installation via command line
19