Siemens SINUMERIK 840D sl Operating Manual page 242

Create MyConfig - Expert
4.4 Project folder
Properties of linked steps
For the step link and all substeps, all step properties are taken into the main project. The step
properties are displayed and saved in the project.
The step properties shown in gray cannot be changed in the main project. The ID namespace
produced by the step link can be changed at any time in the link step marked in blue.
Management of the step configuration is set to the subproject when creating a step link. This
setting can be changed to the management in the main project.
The "Manage in" property specifies whether the step configuration of the gray link steps below
the blue link step should be managed in the main project or in the subproject. For the blue link
step, the step configuration is always managed in the main project.
242
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE