Command Line Call - Siemens SINUMERIK 840D sl Operating Manual

When you open the "Axis-drive assignment" dialog, after importing in the "Axis-drive
assignment" dialog, you will see the "Display: Standard". You can change the configuration.
The axis drive dialog with "Display: Diagnostics" is not available for the topologies in the
topology list.
Figure 6-24 Axis-drive assignment (AAZ) - diagnostics
Configuration Dialog
A configuration dialog box is opened via the icon
"diagnostics" variants offered in the display can be changed with regard to the columns shown
and new user-defined display variants can be added.
6.6

Command line call

Call
Write the commands shown in the following as well as the used switches and arguments in
one line to a batch file or a command line interface.
The significance of the switches and arguments is described in the following Topo-parameter
table.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Create MyConfig - Topo
6.6 Command line call
. In the dialog box, the "standard" and
491