Local Do List - Siemens SINUMERIK 840D sl Operating Manual

The properties of the DO variables assigned to a component are displayed in the "Properties"
dialog.
Figure 6-8
6.4.4.1

Local DO list

Each topology of a project has a separate variable table for local DO lists. Earlier CMC versions
used a global list.
If the same variables are configured for different topologies or projects, link them to an external
list. The behavior so remains the same as for previous CMC versions.
When importing archives, DO variables are automatically formed from the DO names. When
commissioning with Create MyConfig, the DO variables are stored in SINAMICS and are
therefore available again for the archive import.
Unlike previous Topo versions, all data is now retained after the archive import.
DO variables
The yellow
If the
is lost. Further information can be found in the Extended user-specified topology (Page 508)
section.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Component properties
icon shows that data is already linked to the DO.
icon is grayed-out, no data is linked. During renaming or deleting, all axis/drive data
Create MyConfig - Topo
6.4 Topo - operation
473