Project Folder; Package; Specifying The Configuration For Package - Siemens SINUMERIK 840D sl Operating Manual

Support of the CU320 through Create MyConfig
The following processes are supported:
● Administration of the drive data (DO) via the archive (copy, delete).
● Manipulation and access to SINAMICS parameters as for CU Integrated (bus 3) via the
archive (script, manipulation task).
● System configuration for the drives as for CU Integrated.
● Comparison, user-specified and extended user-specified topology as for CU Integrated.
● Configuration of the axis-drive assignment as for CU Integrated, execution during runtime.
● Exclusion of slaves above a selectable address of device configuration.
● External CUs can be excluded from the SINAMICS device configuration and the access to
data by the HMI/CMC (archiving, manipulation and display).
You can find further information at: Prepare (Page 345) function and SINUMERIK
DOConCD.
Note
Take the following requirements into account:
● Make sure that the CU system software and the NCU system software have the same
version.
● Correctly configured PLC SDBs (HW Config) are required.
The following processes are not supported by Create MyConfig:
● FW update and installation of the CU software.
● Adding, changing, deleting files on the CF card.
● Access to the file system of the CU.
4.4

Project folder

4.4.1

Package

4.4.1.1

Specifying the configuration for Package

The basic settings for the package are configured on the "Package" tab.
You can configure the following property groups on the "Package" tab:
● General
● Deployment
● Data areas
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Create MyConfig - Expert
4.4 Project folder
137