Siemens SINUMERIK 840D sl Operating Manual page 16

Installation
2.2 Installation via command line
Parameter
DestinationPath
(optional)
Features
(optional)
DeleteSettings
(optional)
NcuShareService
(optional)
NcuShareServiceShare‐
Folder
(optional)
Example of the control file "OPFILE.txt"
[SETUPREQUESTS]
#
#
#
SetupMode=Batch
#
-------------------------------------------------------------------
#
#
#
#
#
#DestinationDrive=C
#
#
#
#
\SINUMERIK\Create MyConfig 4.8"
16
Description
In this parameter, you can specify a path without drive in‐
formation where you wish to install the software.
A default installation path is used if a value is not entered.
This parameter is ignored if CMC components are already
installed.
In this parameter, you can list the components to be instal‐
led, separated by commas.
Possible values are Expert, Topo, Diff and Samples.
The components correspond to the selection in the setup
dialog for manual installation.
All of the components are selected if a value is not speci‐
fied.
You can clear settings from a previous installation using
this parameter.
If the optional parameter is omitted, the prior settings from
a previous installation will be retained.
The NcuShareService is installed with this parameter.
With 1, NcuShareService is installed - and with 0 is not
installed.
This parameter is used to specify the path for the share
folder.
--- SetupMode
deselection of setup dialogs /
Deselection of setup dialogs
When required, optional parameters can be inserted and adapted. /
Optional parameters can be commented and adjusted as required.
--- DestinationDrive ---
Deselection of the installation drive /
Selection of installation drive
--- DestinationPath ---
Selection of the installation path /
Selection of installation path
default (Windows 64 Bit): "\Program Files\Siemens\Automation
Example
DestinationPath ="\myTools\Cre‐
ate MyConfig 4.8"
"C:\Program Files\Siemens\Auto‐
mation\SINUMERIK\Create My‐
Config 4.8"
● Install all components:
Features=Expert,Topo,Diff,
Samples
● Only install component "Diff":
Features=Diff
DeleteSettings=1
NcuShareService=1
NcuShareServiceShareFolder=
"C:\Users\Public\UpNcuShare"
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE