Philips LPC213 Series User Manual page 223

Philips Semiconductors
Volume 1
Table 193: ISP command summary
ISP Command
Unlock
Set Baud Rate
Echo
Write to RAM
Read Memory
Prepare sector(s) for
write operation
Copy RAM to Flash
Go
Erase sector(s)
Blank check sector(s)
Read Part ID
Read Boot code version K
Compare
20.8.1 Unlock <unlock code>
Table 194: ISP Unlock command
Command
Input
Return Code
Description
Example
20.8.2 Set Baud Rate <baud rate> <stop bit>
Table 195: ISP Set Baud Rate command
Command
Input
Return Code
Description
Example
User manual
Usage
U <Unlock Code>
B <Baud Rate> <stop bit>
A <setting>
W <start address> <number of bytes>
R <address> <number of bytes>
P <start sector number> <end sector number>
C <Flash address> <RAM address> <number of bytes>
G <address> <Mode>
E <start sector number> <end sector number>
I <start sector number> <end sector number>
J
M <address1> <address2> <number of bytes>
U
Unlock code: 23130
10
CMD_SUCCESS |
INVALID_CODE |
PARAM_ERROR
This command is used to unlock flash Write, Erase, and Go commands.
"U 23130<CR><LF>" unlocks the flash Write/Erase & Go commands.
B
Baud Rate: 9600 | 19200 | 38400 | 57600 | 115200 | 230400
Stop bit: 1 | 2
CMD_SUCCESS |
INVALID_BAUD_RATE |
INVALID_STOP_BIT |
PARAM_ERROR
This command is used to change the baud rate. The new baud rate is effective
after the command handler sends the CMD_SUCCESS return code.
"B 57600 1<CR><LF>" sets the serial port to baud rate 57600 bps and 1 stop bit.
Rev. 01 — 24 June 2005
UM10120
Chapter 20: Flash Memory
Descibed in
Table 194
Table 195
Table 197
Table 198
Table 199
Table 200
Table 201
Table 202
Table 203
Table 204
Table 205
Table 207
Table 208
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
223