NEC NEAX 2000 IVS Command Manual page 110

COMMAND CODE
08
BASIC SERVICE FEATURE
432 Forced release when a called ISDN Terminal is no answer
during 3 minutes
434 Assignment of the calling party number which is sent to an
ISDN network when making a call from ISDN Terminal
441 Recall display on the SN610 ATTCON.
442 UCD Busy Out from Sub-line
443 Type of Voice Mail System (VMS)
444 Message waiting lamp control from VMS with MCI to all sta-
tions.
Note: Message Waiting lamp control is only available to
the stations in the opposite PBX connected with the
CCIS via MCI. Station dialing MW access codes
are not allowed over CCIS.
445 Enable depressing the Paging key on SN610 ATTCON when
the ATTCON is in idle.
448 When the Multiline Terminal station dials "*#" during setting
of One-Touch keys.
449 DID call to station with Call Forward – No Answer set over
CCIS to a busy destination station. Destination has no call
forwarding set.
450 Fault Information Storing
451 Processing at the time of the Fault Information Memory over-
flow.
460 Transfer a trunk call into an ACD group from a station or
SN610 ATTCON.
Note: This command is used for NEAX MIS 3.XX or 4.XX
only.
461 Sending of SMFN when answering a held call.
TITLE:
BASIC SERVICE FEATURES
ND-45669 (E)
SETTING DATA
0 Not available
1 Available
0 Calling Party No. entered in ISDN
Terminal
1 Calling Party No. assigned by CM12
YY= 12/13
0 Available
1 Not available
0 Available
1 Not available
0 VMS with MCI
1 VMS with PB signaling
0 Available
1 Not available
0 Available
1 Not available
0 "*#" is set as dialed digit.
1 "*#" is set as a delimiter mark between
dialed number and DTMF signal.
0 Ring continuously at forwarded DID
station
1 Drop to busy signal after time set by
CM41, Y=0 function 01
0 Not performed
1 To perform
0 No fault information is registered in
case of Fault Memory overflow
1 Fault information is overwritten in
case of Fault Memory overflow
0 Allowed
1 Not allowed
0 Sent
1 Not sent
CM08
Initial Data
:
CHAPTER 3
Page 87
Revision 2.0