[Cm50] Common Route Indial - NEC NEAX 2000 IVS Command Manual

COMMAND CODE
50
1. FUNCTION:
This command is used to assign LDNs (Listed Directory Numbers) to DID or Tie lines. When these
numbers are dialed into the system, either on an incoming tie line or an incoming C.O. line set up for
indialing, the call will appear at a specified call identification key on the attendant's console.
The system allows digits to be added to or deleted from indialed numbers on a route basis. This
command, in conjunction with CM35 YY=17, allows two extra leading digits to be specified.
The common route indial facility allows up to eight LDNs to be identified. In addition, this command is
used to assign the access code to be sent to a Voice Message System (VMS) before/after a Mail Box
Number.
2. PRECAUTION:
None
3. ASSIGNMENT PROCEDURE:
ST + 50YY + DE +
[CM50] Common Route Indial
TITLE:
COMMON ROUTE INDIAL
KIND OF DATA
(1 - 3 digits)
ND-45669 (E)
Addendum-001
AUGUST, 1998
DATA
+ DE +
(1 - 12 digits)
CM50
+ EXE
CHAPTER 3
Page 217
Revision 2.1