[Cme5] Station, Trunk Line Make Busy - NEC NEAX 2000 IVS Command Manual

CME5
COMMAND CODE
E5
1. FUNCTION:
This command is used to make busy any station or trunk in the software.
2. PRECAUTION:
None
3. ASSIGNMENT PROCEDURE:
ST
+ E5Y +
4. DATA TABLE:
STATION TRUNK NUMBER
Y
No.
0 X
XXXX
1 000
255
,
2 XXXX X
3 000
255
Note 1: For a station that is made busy, call termination to the station is restricted, but Call origination is available.
For extension lines on a Multiline Terminal, My Line and Multiline make busy can be set individually, with
the same condition as mentioned above.
Note 2: For a trunk that is made busy, the outgoing call is restricted, but on incoming, the call is available.
Note 3: For the B channel that is made busy, call termination to the ISDN Terminal corresponds with the B channel
is restricted, but call origination is available.
Note 4: Under a made busy condition, the Busy Lamp on the card flashes (60 IPM).
Note 5: Make idle of ZT since the ZT is in make busy forcibly when assigning the ZT data by CM10.
CHAPTER 3
Page 348
Revision 2.2
TITLE:
STATION, TRUNK LINE MAKE BUSY
STATION/TRUNK
DE
+
NUMBER
MEANING
Station number
(1-4 digits)
Note 1
Trunk number
Note 2
ISDN Circuit Station No.
0: B1 Channel
1: B2 Channel
Note 3
ZT number
DATA
DE
+ +
(0/1)
SETTING DATA
DATA MEANING
0 Make Busy set
1 In service
0 Make Busy set
1 In service
0 Make busy set
1 In service
0 Make busy (forced)
1 Make idle
2 Make busy
(after calls finished)
ND-45669 (E)
Addendum-002
JANUARY, 1999
EXE
+
REMARKS
For LC, AUC, and
DLC card
For COT, LDT,
ODT, 2BRT, and
AUC card
For ILC card
For ZT
Note 5
: Initial Data