NEC NEAX 2000 IVS Command Manual page 204

COMMAND CODE
35
MAT
Note 1: In case of CM35 YY = 76, Data = 15, not specified (release the sender by time out or by answer
signal from the called distant office).
In case of CM35 YY = 76, Data = 00 – 04, specified by the dialed digits assigned by CM85.
Note 2: STN means the calling party's station number, and this number is sent automatically by CM30 –
28, Data = x6.
Note 3: LED indication for an internal incoming call is red (120 IPM flashing). For indicating the ter-
mination of transferred external incoming call, the flashing LED color depends on CM08-137.
Note 4: For incoming calls to a Trunk-Direct Appearance key on Multiline Terminal, the special ringing;
0.2 sec. ON – 0.2 sec. OFF is applied.
Note 5: Maximum number digit analysis should be provided to prevent one way calls (See CM35 YY =
76, CM85 and CM8A YYY = 400 – 407).
Note 6: When the Trunk Route is assigned as a C.O. line, the data for YY = 56, 57 and 58 are automati-
cally set to "Restricted".
Note 7: When the Trunk Route is assigned as a C.O. line, the data for YY = 68 is automatically set to
"Restricted".
Note 8: Both circuits must be set as either 2-wire or 4-wire in one PN-2ODT card; they cannot be both.
[CM35] Trunk Route Data
TITLE:
TRUNK ROUTE DATA
ND-45669 (E)
Addendum-001
AUGUST, 1998
CM35
CHAPTER 3
Page 174-1
Revision 2.1